- How long does it take to press vinyl?
- How is a vinyl record cut?
- How does a record work?
- Is vinyl better than CD?
- Does playing a record damage it?
- Is it bad to leave a record player on all night?
- What is a lathe record?
- Can I touch a vinyl record?
- Can you make your own vinyl records?
- What are the different lathe cutting tools?
- How much does it cost to press a record?
How long does it take to press vinyl?
roughly 3-4 weeksOnce your order form, music, and deposit have been received it can take roughly 3-4 weeks for your test pressings to be shipped.
Once you approve your tests and all of the components (jackets, inserts, stickers, etc.) have been received it typically takes 3-4 weeks for your order to be completed..
How is a vinyl record cut?
Cutting: Recorded Sound onto the Lacquer Disc The engineer places this blank disc onto a recording machine, AKA a lathe. … As the recorded sound plays through the machine, the sapphire tip cuts the recording’s sound waves into the surface of the disc, with a small vacuum sucking up the lacquer that’s being cut out.
How does a record work?
Sound waves were directed into the diaphragm, making it vibrate. A hand crank turned the cylinder to rotate the tinfoil cylinder while the needle cut a groove into it to record the sound vibrations from the diaphragm. … The amplified vibrations played back the recorded sounds.
Is vinyl better than CD?
You are wrong – vinyl sounds better than CD. There is NO WAY that the digital process can preserve the original analog signal by chopping it up into numbers and reconstituting it. … Vinyl provides a warmth and immediacy that digital can’t, and provides more continuity in the music.
Does playing a record damage it?
As for wear-induced noise, most of that comes from playing records with a worn-out or damaged stylus (aka needle) that’s literally gouging the grooves with each play. Any decent cartridge will play records without damaging the groove. … A force setting that’s too high or too low can accelerate record wear and noise.
Is it bad to leave a record player on all night?
Your player could loop in the same spot all night long and ruin your record. … You should certainly not leave a vinyl record on your record player for long periods of time unless by accident. It is a good idea to make a habit of always putting the record back in its sleeve and putting it away after every use.
What is a lathe record?
A lathe cut record is an instant vinyl record. Lathe cutting is the fastest way to make a retail ready record. A one off vinyl can be made in minutes where one off custom vinyl pressing can take weeks.
Can I touch a vinyl record?
Never touch the record’s playing surface with your bare hands or fingers as your body oil will transfer onto the record attracting even more dust thereby affecting sound quality. … If you accidentally touch a record, it is best to immediately clean it with a liquid record cleaner before putting it back in its sleeve.
Can you make your own vinyl records?
Vinylify makes personalized vinyl records on demand. You decide what music you want on your record and create your own cover art. We’ll take care of the rest and deliver the record to your door so you can start spinning.
What are the different lathe cutting tools?
Different Types of Lathe Cutting ToolsTurning Tool. … Boring Bar. … Chamfering Tool. … Knurling Tool. … Parting Tool. … Thread Cutting Tool. … Facing Tool. … Grooving Tool.More items…•
How much does it cost to press a record?
How Much Does Vinyl Cost? Rates usually depend on the length of the record per side. This can range from $150 – $230 per side ($300 – $460 per record) with the average being around $200 per side ($400 per record).